Blue Chip Structures

	7. Set side sections with top connector flange down.
	8. Slide four (4) corner connectors on sides to assemble. Tap in place with mallet if necessary.
9. Set side sections with top connector flange up. Slide first roof section into roof connector flange. 10. Slide the other roof sections into place from left to right. Mitered edge should be exposed on underside to give a finished appearance


	11. Bolt roof cap onto roof sections. Nuts are furnished with lock washers to grip metal-finger tighten only, at this point. 12. Start each roof connector approximately 4" on each corner. 13. Continue to tap each roof connector on with a mallet or hammer. Drive each connector on approximately 4-6" at a time.